LL-37 Reconstitution, Concentration and Storage: Research Guide (2026)

LL-37 is a 37-residue cathelicidin antimicrobial peptide and the largest product covered in this series. Its length, charge and membrane activity make both reconstitution and assay design sensitive to concentration and ionic strength. This guide covers preparation, dilution and storage. All compounds and procedures on this page are for laboratory research use only.

A Long, Cationic Antimicrobial Peptide

LL-37 is the only human cathelicidin-derived antimicrobial peptide and is studied in innate-immunity, biofilm and membrane-interaction research. At 37 residues with a strong positive charge, it is a demanding reagent: it can adhere to surfaces, its activity depends on ionic strength, and at high concentrations it can self-assemble. Reconstitution should therefore target a clear, moderate-concentration stock rather than the highest achievable concentration.

Reconstitution and Solubility

Sterile water is the usual diluent. If the peptide resists dissolution, a small volume of dilute acetic acid can help, but the change must be recorded because pH and ionic strength both affect antimicrobial assays. Add solvent slowly down the wall, roll gently, and inspect against a dark background. Do not vortex a long cationic peptide; shear and foaming are real risks.

Concentration and Assay Design

A 5 mg vial in 1 mL gives 5 mg/mL; in 2 mL, 2.5 mg/mL. Antimicrobial assays are commonly run in the microgram-per-millilitre range and are sensitive to salt concentration, so the diluent and the assay medium must be matched deliberately. Prepare a documented serial dilution in the same medium used for the assay, and keep a vehicle-only control for every plate.

Storage, Adsorption and Batch Records

Store the dry vial cold and dark. Refrigerate the reconstituted stock and use it within the documented window; aliquot before freezing. Long cationic peptides adsorb strongly to some plastics and to glass at low concentrations, so use low-binding tubes for dilute steps and avoid unnecessary transfers. Record vial batch, COA purity and preparation date so that repeat runs start from the same material.

Key Research Points

  • LL-37 is a 37-residue cationic cathelicidin with strong surface adsorption and self-assembly tendencies.
  • Target a clear, moderate-concentration stock rather than the maximum achievable concentration.
  • Antimicrobial assays are ionic-strength dependent; match diluent and medium.
  • Use low-binding tubes for dilute steps and avoid unnecessary transfers.
  • Record batch, purity and preparation date for repeatability.

Quick Reference

Vial size Diluent volume Resulting stock
5 mg 1 mL 5 mg/mL (5,000 ug/mL)
5 mg 2 mL 2.5 mg/mL (2,500 ug/mL)
5 mg 5 mL 1 mg/mL (1,000 ug/mL)
10 mg 2 mL 5 mg/mL (5,000 ug/mL)
10 mg 5 mL 2 mg/mL (2,000 ug/mL)

Frequently Asked Questions

Why is LL-37 harder to handle than short peptides?

It is a 37-residue cationic peptide that can self-assemble and adsorbs strongly to surfaces.

Does salt concentration matter?

Yes. Antimicrobial activity is ionic-strength dependent, so match the diluent to the assay medium.

Can I use acetic acid to dissolve it?

A small amount of dilute acetic acid can help, but record the final pH because it affects the assay.

How do I limit adsorption losses?

Use low-binding tubes for dilute steps and minimise transfers between containers.

Related Research Guides

Browse the LL-37 research product with batch-matched COA documentation.

Closing Note

LL-37 is the most demanding reagent in this series: long, cationic and surface-active. Dissolve gently, keep the stock moderate, match the diluent to the assay, and document the batch. The aggregation and storage guides cover the related failure modes.

Sources

  • Content compiled from published peptide research literature and documented research-supply practices (2026).
  • Vial sizes and handling notes should be verified against the current product page and the batch COA.
  • This page is an informational research guide, not medical advice and not legal advice.

Related Reconstitution Guides

All products on this site are supplied for laboratory research use only and are not for human consumption.

Leave a Reply

Your email address will not be published. Required fields are marked *